Sunday, September 15, 2013

Festool Style Bench

SketchUp Drawing

Hard maple, black melamine sheet, Record vise

Kreg bench dogs

Zyliss Carving Station

Bench assembled with 1/2" bolts

Clamping Racks

3/4" Delrin studs fitted on the bottom for mounting in the hole pattern

Aux Table in place


Aux Table setup for carving


Base Cabinet begins

Drawer boxes complete and installed...drawer fronts are next

Lower cabinet is finished

Another view


7 comments:

  1. hey, what did you use to laminate the top of this table with ? did you do both sides ?

    ReplyDelete
    Replies
    1. Standard black melamine sheet (black both sides). 32" x 60". Regards, Mike

      Delete
  2. Positive site, where did u come up with the information on this posting?I have read a few of the articles on your website now, and I really like your style. Thanks a million and please keep up the effective work. CutTheWood.com - Woodworking DIY

    ReplyDelete
  3. Really like your bench but was wondering if you have any problems with the vise chops being so wide? I have a mft style bench 80x40 roughly and would like a full width end vise.

    ReplyDelete
  4. Really like your bench but was wondering if you have any problems with the vise chops being so wide? I have a mft style bench 80x40 roughly and would like a full width end vise. If possible email me at Rlroby83@gmail.com

    ReplyDelete
  5. Thanks for your post. I’ve been thinking about writing a very comparable post over the last couple of weeks, I’ll probably keep it short and sweet and link to this instead if thats cool. Thanks. lathe for beginners

    ReplyDelete
  6. Hey what a brilliant post I have come across and believe me I have been searching out for this similar kind of post for past a week and hardly came across this. Thank you very much and will look for more postings from you. outdoor furniture

    ReplyDelete